Procedure

• Open the fixture by unclipping the two lens ring clasp
• Remove the lens ring and lens together as one assembly
• Unscrew the two screws securing the light engine.
• Disconnect the LED cable from the driver board.
• Carefully remove the existing light engine from the base.

Note: If an arctic kit is installed you must unplug the arctic kit with the light engine

• Clean any debris or residue from the inner edge to ensure a proper seal.
• Plug in the new light engine to the LED connector.
• Position the light engine so the mounting hole is opposite the driver board.
• Secure it using the two mounting screws.

Reinstall the Lens Assembly

• Match the lens color with the LED side (if applicable).
• Align the two recesses on the lens ring with the tabs on the base.
• Lower the assembly into place and latch both clasps securely.